This setting changes the way the Haas control recognizes the work offset system when a G52 or G92 is pro- grammed. It can be set to FANUC, HAAS, or YASNAC.
Set to YASNAC
G52 becomes another work offset, just like using a G55
Set to FANUC with G52
Any values in the G52 register will be added to all work offsets (global coordinate shift). This G52 value can be entered either manually or through a program. When FANUC is selected, pressing RESET, commanding an M30, or machine power down will clear out the value in G52.
Set to HAAS with G52
Any values in the G52 register will be added to all work offsets. This G52 value can be entered either manu- ally or through a program. The G52 coordinate shift value is set to zero (zeroed) by manually entering zero, or by programming it with G52 X0, Y0, and/or Z0
Set to YASNAC with G92
Selecting YASNAC and programming a G92 X0 Y0, the control will enter the current machine location as a new zero point (Work Zero Offset), and that location will be entered into and viewed in the G52 list.
Set to FANUC or HASS with G92
Selecting FANUC or HAAS with a G92, it will work like the YASNAC setting, except that the new Work Zero location value will be loaded as the new G92. This new value in the G92 list will be used, in addition to, the presently recognized work offset to define the new work zero location.